|
|
View Full Version : 3.0 V6 Tech
- Seafoam Trouble Help!!!! Read Now [The DeeDeeDee remix]
- I dont think its the idle pully squeeking......
- the engine to replace the 3.0 in the ranger
- Cat question
- Check engine light
- Bottom End Pics?
- 3.0l MAC intakes, please dont tell me my K&N wasnt worth another hundred bucks
- LIL 3.0 help
- aluminium intake manifold
- New Eaton Supercharger For The Ranger!!! [New if you're a n00b....]
- TPS sensor
- ranger v6 3.0 supercharger
- 0-60 time
- nitrous problem
- underdog
- throttle position sensor for 5.0 throttle body
- Roller Rocker Installation Kit
- O2 Sensor Question
- blown head gasket
- Best year engine to start with?
- Gibson headers for 3.0 for alot less than JBA's!
- Flamethrower for EFI?
- MAF Mod service?
- Alternator only 7 year life ? HO's discontinued ?
- Another seafoam post. I did a search...
- performance pumps?
- engine stalling (almost) when stopping
- Bad loss of power
- misfire at 4000 rpm
- I have the NEW Volant Air intake 3.0L
- A little off-topic, but do you think my truck will be totaled? Details inside...
- Exhaust
- Suggestions on Rebuild or Scrap
- How do you clean the IAC Valve?
- MAF/Air Filter set up, CaM synchronizer, What'd nose did i break? Quick questions.
- Holy Schnikeeeees!!!!!
- I need a motor
- fuel pump not kicking on..
- 3.0 performance-better mpg
- coil pack clicking, still having problems with motor
- SeaFoam :How To:
- injector cleaner
- Alternator
- compression test numbers
- temp guage weird happenin's
- how do you change the serpentine belt
- weird engine click/clunk
- Fuel Filter
- higher rpms?
- ebay cd rom
- starter freezes up in cold weather
- We are building a V8 Ranger to compete, and benefit charity!
- Keeping it Alive
- MSD Blaster Coil 2
- NOS problems still
- Dead Ranger
- cam synchro ford or aftermarket
- Sensors and Data Logging
- LiveWire vs. Xcal2
- best bang for you buck
- O2 Sensors - Motorcraft vs. Bosch
- 50hp gain from tune
- 1/4 mile times
- crushed vs. mandrel
- Looking for a NOS kit
- tuning
- 3.0 Quarter mile
- can't find a 5 heat range plug
- So I got the money...
- empty the cat
- Well, it was fun while it lasted...
- Stupid question
- were can i get preformance parts for 94 3.0L?
- was stumbling at start up
- maf sensor upgrade
- replacement spark plug wire holders?
- Quick help!!!
- Intermittent Low Idle on Cold Start?
- rattle under the hood
- 3000 RPM Miss
- Fix Me!
- New to the world of Rangers...
- Fuel Mileage???
- Coolant leak...Need help
- MPG from 3.0 V6 guys - stockers
- Rev limiter question.
- X-tuner: what else?
- Copper or iridium with nitrous.
- Low RPM Knock
- A little taste of my new combo
- Not a 3.0 or a ranger but.....
- Stopping the squeaking belt
- what can WE do about this cam synro problem?
- Aluminum or Composite Intake
- quick question
- building an intake.
- 3.0 guy on his way out.....sniff sniff
- Speaking of 3.0 guys leaving....me too....
- Injectors and fuel filter
- 1999 engine,tranny swap
- 01 ranger w/ cylinder 3 misfiring
- GL-R headers - I have to go custom
- what size is crankshaft bolt on 3.0 l vulcan
- knocking sound
- msd dis 4
- X-cal program questions
- jba ceramic coated headers
- Power Steering Pump
- Changed Spark Plugs and Wire Set...but...
- finding TDC notch
- Plugs
- What is my truck's problem!?!? head gasket?
- Back to the forums!
- pullys
- TC Mod
- 3.0 OverDrive?
- Can anyone verify a p/n...
- starter mods
- Help Quick
- powerband
- Changing Pre-Cat O2's
- Track times
- March Power Pulleys
- Thou shalt not underestimate the power of the XCal2/LiveWire (...or the BOSS)
- What will I get with mods
- Maf?
- i've done it! composite upper on alum lower
- side exhaust
- FYI......Flowmaster suck
- Pushrod length
- No more ping
- Iat?
- E-Fan
- Too high RPMS?
- Exhaust Manifolds - BOSS chime in!!
- vulcan?
- code 35, lean bank 1
- Sarter Question
- 3.0 mod help....
- Oil Change
- how to tell the difference
- Idea's for my baby!
- udp's
- Which exhaust!
- Belts
- Royal Purple??
- Cgeck engine light/check fuel cap light on.
- BOSS's New Avatar
- Fuel Cutoff Switch?
- Another airbox mod(dont worry i searched lol)
- could my truck be in limp mode?
- quick question
- Brake booster Line location
- read
- glasspack dual exhaust
- thrush glasspack question
- pulsating squeal at idle?
- Truck Smokes and Gets Bad mpg
- gutted cat
- 3500 RPM - red line backfire
- Top Speed is 110Km/h?!?
- CEL throwing P0401
- Underdog's Screamin' Demon Coil Pack
- Woot Woot
- Ranger Ignorance
- easy and cheapest mods
- Keeping with my PM and a problem,,,
- Starting Prob. Dealership Cant Fix.
- msd
- Headers
- Um
- Power Surge
- DPFE keeps failing...what could be wrong?
- Clutch replacement?
- 07 With a Warranty
- Replace Belt Tensioner?
- spark plugs at 0.060"...WTF!
- Temperature increase; hose is contracted
- new motor - new problem?
- Tune up
- 96 3.0 engine swap
- Exhaust
- PCV valve hose
- My ticking problem
- Boss - Any Word On Sct's Engineering Codes?
- exsaust question
- Under Powered 3.0
- Metal Shrapnel Found in Oil.
- another exhaust question
- Turndown or tailpipe
- dynomax muffler question
- anybody with a 1993
- Did an oil change, and found some interesting things..
- motor mount advice
- i decided to install the intake!
- does anybody own a 1993
- Emissions
- Can you drop a cylinder or two without a CEL?
- Escape TB mod
- opinion on slp loudmouth catback exaust
- engine
- Puff of Smoke...
- Intake Fit
- 0w-20 same as 5w-20?
- Idea!!!
- P&P question
- EGR bypass?
- crank question
- Air intake hose to the rocker cover?
- ranger/b3000
- I Got My Dynomax Put On
- Check Gauge Light
- Finally did the pulley and TC mod
- Noise Diagnosis..
- manifold.. what should i do?
- my custom dual exhaust
- pulled cel
- At 6,000 rpm's for a quick second...
- Lean Fuel Conditions and...Pinging
- A couple questions.......
- head swap
- New problem!
- Ideas on a Custom Intake
- Cold start and wants to stall...
- Tough Start and rough idle
- Odd noise
- studders when shifts
- LOUD knock - conversion?
- Does any one know?
- valve cover gasket
- fuel punp
- Engine Temp.
- Lower intake manifold.....
- New To The Site..and soon Rangers....
- Your 3.0 durability/longevity/high miles/reliability/mod-able story?
- Exhaust size
- EGR flow
- Newbie Questions
- Overdrive Bog Maybe?
- plug wires
- bolt size for exhaust mani
- finally exhaust
- Goodbye 3.0 board!
- anybody do a p&p on the composite?
- General Maintanence??
- roller rockers
- Aluminized exhaust and high temperature coatings
- Fouled plugs after 3000 miles???!!!!
- Compatible 3.0Ls
- Supercharged
|
vBulletin® v3.7.3, Copyright ©2000-2010, Jelsoft Enterprises Ltd.