I just picked up my trailer fenders for under the hood, after looking i need to know what will be the best way to relocate the ABS on the driver side, and other than moving some wiring around what else do i need to do..
if it matters I have a 3.0 flex fuel

Mine is now where the AC compressor was. but i do have an ABS light

depending on what mood my truck is in i have a ABS light to..sometimes my truck really likes me and the speedo works...lol

Mine is now where the AC compressor was. but i do have an ABS light

were the lines just extended?..got any pics?

we made a new bracket for mine. wasn't too hard. mounted it off the ac compressor bracket. bascially we moved it to the left and up a bit. gave me all the clearance i needed

i got rid of my abs... liked the bracket idea tho

witch ones the abs? i cant think of it right now lol.

we didn't extend any of the lines...just manhandled them a little.Since my ABS light is on and it's probably not functioning i'm probably going to pull it.

so you can just take it out, nothing else you have to do?

when i yanked mine i just redid the brake lines form the brake booster to the existing lines that came off the abs...

sweet..thanks for the help guys

Iv'e been told about adding a proportioning vavle to the rear.

i was giong to say if you guys are thinking about taking your ABS out completely i would definitly get a proportioning valve for the rear to prevent it from locking the rear up so easily. i was planning on deleting mine when i get around to it.

I pulled mine out and just redid the lines