Hey guys I have a 3.0L and i am tryin to lay my ranger out....
The problem I am having is the 5 catalytic converters...I did remove the last one only b/c there is no O2 sensor...
The problem I am having is the four cats remaining. I dont want to remove them and have my truck run like $hit.... I am currently laying on the bend of the exhaust where the cats are located. How have you guys corrected this problem? Thanks guys
P.s. I have searched but i am still unsure which route to take

mine were removed... the truck runs fine u just loose alittle low end torq.

do you have smog checks there?

if so you will need to have them moved or one installed that will do the job of them all. i woudl get a x-cal to keep the cel comeing too

I don't have smog checks, but i thought the first two O2 sensors were the ones responsible for sending back signals to the comp regarding fuel mixture but i wasnt sure....I thought it would be good to keep them but Rangerbrown can u elaborate on what to do?
Thanks for the help guys....