Ok this thread may get moved but anyways..when i'm standing behind my truck, the right side of my bed is probably about 4 inches lower than the left side. looks horrible when your behind it, but a few ppl have said its normal and its no harm. Does anyone know the cause of this? or even how to fix it?

mines not crooked, I don`t think it`s normal, I got 2 buddies with rangers, theirs are pretty level also, ck your bed mounts, frame & leaf springs

hmm i dont know..i've seen a few rangers with a crooked bed. seriously though, it looks like a$$. i can get a pic sometime but i dont have a cam with me right now..

If you look at mine from the back the right side is just barely a little off. Been that way since it was new.

Maybe it is the Ranger lean?

mmm the old ranger lean we all have it
now if it is 4inches then there is a problem

Has your truck ever been in a wreck?

bed mounts or lack of..

a little off is normal, but not 4 inches, when I got mine new, the workers who installed it at the factory must have been blind !, the gap on the drivers side was about 1 finger, the pass side was over 4 fingers, stuck out towards the drivers about 1 inch !, great quality control !

yea..its off pretty good. I dont think the previous owner was in a wreck. 4 inches is probably exaggerating but its BAD!! haha...its almost like the sheet metal in the bed is warped..

loosen the bed up and shift it a little and see if that helps

i can only try..thanks for the info guys