I have a EFI 302 with an RCI fuel cell in the bed and will be looking to purchase an electric in line fuel pump. Just wondering what others are running.

i'm runnig a holley projection pump part#512-103 it was about $140

We are running an Aeromotive 1000 with a 40 micron filter before and a 10 micro filter after the pump, a picture is below. We used an Aeroequip AN-8 90* bulkhead fitting to go through the bed. We used an AN-6 90* for the return line and the same setup with an AN-4 for the vent line. We used a top return line to prevent aeration of the fuel close to the pick-up (feed) line and also not to return warmed fuel close to the feed line. Just be sure to mount your pump lower than the tank.


http://home.earthlink.net/~niestrath/Fuel-filter-1.JPG

http://home.earthlink.net/~niestrath/New-fuel-cell-3.JPG

i'm doing a job now ('72 302", but carbed) which is some performance, like the manifold (edelbrock), carb (edelbrock), ignition (mallory), headers (hedmen).

i just picked up a Purolator electrical fuel pump at PEP Boys for $32.99...before tax. that should be good enough for this 302 project, however, the truck isn't for offroading or dragin, just mainly driving around with a big head.