I'll have some time slips in a few weeks.

here's the intercooler

Dang, what a cooler!! That's not a powerstroke IC is it? Bet its some more kind of effective...

I got it off of e-bay. The guy said it was from a dodge dakota turbo desil that was made in brazil.

:nuts: Dude i am lookin forward to seein those time man!:drunk:

Thats a cool lookin setup!! What kind of HP are you lookin for? i had a 2.3 turbo in my 85XR4Ti, great little motors. What kind of mods to the motor?

I don't know what kind of HP I'm make. I really don't care about it too much. I'm just looking for 1/4 times. In the spring I'm going to put it on the dyno to fine tune everything. But until then I won't even make an assumption as to what kind of HP I'm making.

So far I have a Ranger roller cam, 3" exhaust from the down pipe to dual out the back 3" pipes, Gutted upper and knife edged lower intake, K&N, MSD digital 6, cleaned up the head a little bit, ported E6 exhaust manifold and 14psi of boost.

I have a set of 4.10 in my garage waiting to go in next week. And the final parts of the intercooler hookup are being made. I have a 1/4" steel plate to mount my by-pass vavle on and I killed my 1 1/8" hole saw trying to drill threw it. So when my new one comes in I can finish the hole and weld the plate on and my intercooler will be hooked up.